8/16/2023 0 Comments Powervu softcam keyThis mean is ready to receive the EMM for the UA listed in your emm key line in softcam. I was looking for this file, but it happens that all the. Its a pretty slow process cause i have to found the the channel SID and insert into the group for ECM keys and also create a group with the EMM key. **(reader) oscam_emu EMM: reader 0E00 match since emmpid has no provid -> SEND!*** The only way that i found to do it is to take the ECM/EMM key from powervu EMU (windows) softcam.key and translate to use for oscam-emu. The best way for you is to follow this points,which by no means are the best there are,is just the way is working for me,some steps might not be needed,and i might just forget something.Ĭheck the live log,a line similar to this one should show up Once you do all this,tune the channel,go to LIVE LOG and expect to roll keys,can take several minutes. Once you do this,make sure you have EMM keys in your softcam file.You need to specify which channel will autoroll in the line,if you want it to autoroll in every channel,you must add a line for every channel. This should be enough to get you started. In config/global make sure you have EMM LOG enabled,with initial debug level of 64,so you can check emm logging. In config/user/oscam-emu set EMMCACHE = 2,2,2,0 In config/dvbapi make ure AU is enabled for the user In config/users make sure linuxsatsupport AU = 1 Oscam_emu and linuxsatsupport must be ACTIVE. Make sure you have this done in order to autorollĬheck in oscam webif if the user is set to autoroll,
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |